1. Which is the chief characteristic of wet and dry tropics?

Answer: Constant heating

Reply

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->Which is the chief characteristic of wet and dry tropics?....
QA->Which is the chief characteristics of wet and dry tropics?....
QA->Which type of winds are found in the tropics towards the Earth"s equator?....
QA->Which does not wet the walls of the glass vessel in which it is kept?....
QA->What is the main cause of extinction of species from tropics?....
MCQ->The diagram given below shows the schematic relations of temperature and precipitation of tropical climatic type over land: Decreasing Temperature 1234 Increasing Precipitation. Arrange the climatic types in the right sequence from left to right: 1. Monsoon topics 2. Wet and dry tropics 3. Arid and semiarid 4. Rainy tropics Select the right answer using the code given below.?...
MCQ->In a laboratory test run, the rate of drying was found to be 0.5 x 10-3 kg/m2.s, when the moisture content reduced from 0.4 to 0.1 on dry basis. The critical moisture content of the material is 0.08 on a dry basis. A tray dryer is used to dry 100 kg (dry basis) of the same material under identical conditions. The surface area of the material is 0.04 m2/kg of dry solid. The time required (in seconds) to reduce the moisture content of the solids from 0.3 to 0.2 (dry basis) is...
MCQ->The wet bulb temperature is lower in dry air than in wet air at the same temperature. A dry bulb thermometer registers a higher temperature than a wet bulb thermometer except at __________ percent relative humidity....
MCQ->Match the following : a. Acrylic 1. Melt spinning b. Kevla 2. Wet spinning c. PET 3. Dry spinning d. Triacetate 4. Dry-Jet wet spinning...
MCQ->200 kg of solids (on dry basis) is subjected to a drying process for a period of 5000 seconds. The drying occurs in the constant rate period with the drying rate as, Nc = 0.5 x 10-3 kg/m2.s. The initial moisture content of the solid is 0.2 kg moisture/kg dry solid. The interfacial area available for drying is 4 m2/1000 kg of dry solid. The moisture content at the end of the drying period is (in kg moisture/kg dry solid)...
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution