Toggle navigation
Home
KPSC Previous Question Papers
Article Category
kerala psc
upsc
General
Popular Pages
Multiple Choice Question in കറന്റ് അഫയേഴ്സ് മേയ് 11
Multiple Choice Question in കറന്റ് അഫയേഴ്സ് - ഏപ്രില് 07
Multiple Choice Question in current-affairs-2016-12-22
Multiple Choice Question in current-affairs-2017-01-22
Multiple Choice Question in biochemistry-structure-and-properties-of-peptides
Multiple Choice Question in കറന്റ് അഫയേഴ്സ് - ക്വിസ് | ഡിസംബര് 05 - 12
Multiple Choice Question in biochemical-engineering-fluid-flow
Multiple Choice Question in biochemistry-allosteric-effects
Multiple Choice Question in current-affairs-2017-05-07
Multiple Choice Question in കറന്റ് അഫയേഴ്സ് മേയ് 26
Question Answer Bank
Multiple Choice Question Bank
Question Answer Category
Multiple Choice Question Category
Home
->
Multiple Choice Questions
Question Set
chemical engineering chemical engineering basics
1. Energy required to compress a hot gas as compared to cold gas will be
(A): less.
(B): more or less depending upon the nature of the gas.
(C): more.
(D): same.
Previous Question
Show Answer
Next Question
Add Tags
Report Error
Show Marks
Ask Your Doubts Here
Type in
(Press Ctrl+g to toggle between English and the chosen language)
Post reply
Comments
Show Similar Question And Answers
QA->The ionisation energy of hydrogen atom in the ground state is x KJ. The energy required for an electron to jump from 2nd orbit to 3rd orbit is?....
QA->Which element on adding to natural rubber makes it less sticky in hot weather and less hard in cold weather?....
QA->When will a hot body radiate maximum energy?....
QA->The heat energy required to raise the temperature of one gram of water by 1°C is called one?....
QA->A white solid’A’on heating gives off a gas which turns lime water milky.The residue is yellow when hot but turns white on cooling .The solid A is:....
MCQ->Energy required to compress a hot gas as compared to cold gas will be....
MCQ->Match List-I with List-II and select the correct answer using the codes below A)Mediterranean 1.Temperate cycle is moderated by marine influence B)Marine west coast 2.Warm summers and cold winters with three months below freezing.Very large annual temperature range C)Dry mid latitude 3.Strong temperature cycle with large annual range.Warm summers to hot and cold winters to very cold D)Moist continental 4.Temperature range is moderate with warm to hot summers with cold winters A B C D....
MCQ->A two stage compressor is used to compress an ideal gas. The gas is cooled to the initial temperature after each stage. The intermediate pressure for the minimum total work requirement should be equal to the __________ mean of P1 and P2.(where, P1 and P2 are initial and final pressures respectively)....
MCQ->The calibration data of a thermocouple with its cold junction at 0°C are given below. The hot junction of the thermocouple is placed in a bath at 80°C, while its cold junction is at 20°C. What is the emf of thermocouple ?....
MCQ->The hot resistance of a tungsten lame is about 12 times its cold resistance. Accordingly, the cold resistance of a 60 Ω, 120 V lamp is about __________ ohm.....
×
×
Type The Issue
×
Your Marks
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...
Privacy
|
Terms And Conditions
Question ANSWER With Solution