Question Set

1. When a fluid flows over a solid surface, the





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The process of transfer of heat from one point of a fluid to another part of a fluid by the movement of fluid itself is called?....
QA->A​ ​white​ ​solid’A’on​ ​heating​ ​gives​ ​off​ ​a​ ​gas​ ​which​ ​turns​ ​lime​ ​water milky.The​ residue​ ​is​ ​yellow​ ​when​ ​hot​ ​but​ ​turns​ ​white​ ​on​ ​cooling​ ​.The solid​ ​A​ ​is:....
QA->The total normal force exerted by a fluid on a surface is called?....
QA->If a liquid wets a solid surface; what is the angle of contact?....
QA->A liquid will not wet the surface of solid if the angle of contact is which angle?....
MCQ->The following statements relate to the pressure exerted by a fluid on a Submerged curved surface : 1. The vertical component of hydrostatic force acting on a submerged curved surface acts through the centre of volume of the fluid directly above the submerged area. 2. The horizontal component of the force acting on a curved surface is the hydrostatic force acting on the vertical projection of the curved surface. 3. The resultant force on a curved surface acts on the bottom of th6 curved surface. Of these statements :....
MCQ->Bernoulli's equation for fluid flow is derived following certain assumptions. Out of the assumptions listed below, which set of assumptions is used in derivation of Bernoulli's equation ? A. Fluid flow is frictionless & irrotational. B. Fluid flow is steady. C. Fluid flow is uniform & turbulent. D. Fluid is compressible. E. Fluid is incompressible.....
MCQ->When a fluid flows over a solid surface, the....
MCQ->Comprehension : The Yellow River is the second largest river in China - over 3000 miles long. It rises in the mountains of Tibet and flows right across China to the east coast. The Yellow River or Hwang Ho. flows into the Yellow Sea. or Hwang Hal. The Yellow River flows into....
MCQ->200 kg of solids (on dry basis) is subjected to a drying process for a period of 5000 seconds. The drying occurs in the constant rate period with the drying rate as, Nc = 0.5 x 10-3 kg/m2.s. The initial moisture content of the solid is 0.2 kg moisture/kg dry solid. The interfacial area available for drying is 4 m2/1000 kg of dry solid. The moisture content at the end of the drying period is (in kg moisture/kg dry solid)....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution