Question Set

1. Preheating temperature of medium viscosity furnace oil for better atomisation through burner is about __________ °C.





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Viscosity of gas is less than viscosity of?....
QA->To make better, to improve or to lift to a better place....
QA->If temperature rises; what will be the coefficient of viscosity of liquid?....
QA->If temperature rises, what will be the coefficient of viscosity of liquid?....
QA->With increase in temperature, viscosity .?....
MCQ->Correct viscosity of furnace oil at the burner tip for proper atomisation is about 25 centistokes. To reduce the viscosity of high viscosity furnace oil (250 centistokes) to the correct atomisation viscosity (i.e. 25 cst), it should be preheated to about____°C.....
MCQ->Preheating temperature of medium viscosity furnace oil for better atomisation through burner is about __________ °C.....
MCQ->Combustion of furnace oil in a furnace (soaking pit) with preheated combustion air at 400°C results in saving of about __________ percent furnace oil as compared to its combustion with atmospheric air, if the flue gas outlet temperature from the soaking pit is 1200°C.....
MCQ->Maximum viscosity of tar/PCM/fuel oil for easy and efficient atomisation in conventional burner is __________ centistokes (or 100 Redwood I seconds).....
MCQ->Which of the following varies as the square root of oil pressure during atomisation of fuel oil through a pressure jet burner ?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution