Question Set

1. Liquid argon level in a pressurised storage tank (at 3 kg/cm2 ) is measured by a/an





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The pressure at the bottom of a liquid tank does not depend on which area?....
QA->The velocity of flow of a liquid through an orifice at the bottom of a tank depends on the?....
QA->Which connects the ocean floor level with the continental level?....
QA->Which connects the ocean floor level with the continental level ?....
QA->A pendulum clock is set to give correct time at the sea level. This clock is moved to a hill station at an altitude of 2500m above the sea level. In order to keep correct time on the hill station, the length of the pendulum?....
MCQ->Liquid argon level in a pressurised storage tank (at 3 kg/cm2 ) is measured by a/an....
MCQ->Assertion (A): In liquid system the ratio of change in liquid level to change in flow rate is called resistance of liquid flow.Reason (R): In liquid level systems the ratio of change in liquid stored in a tank to the change in head is called capacitance of tank.

....
MCQ->Height of liquid in agitation tank is normally maintained equal to the tank diameter. However, if the tank is too tall and a large liquid hold up is desired, then two or more impellers mounted on the same shaft may be used. The clearance between the tank bottom and the bottom most impeller should be about (where, D = impeller diameter)....
MCQ->A water tank has one inlet, A and one outlet, B. A takes 5 hours to fill the empty tank, when B is not open and B takes 8 hours to empty the full tank, if the tank is three fifth full, how much time will it take to fill the tank completely when both A and B are opened simultaneously ?(in hours)....
MCQ->Water is entering a storage tank at a temperature T0 and flow rate Q0 and leaving at a flow rate Q and temperature T. There are negligible heat losses in the tank. The area of cross-section of the tank is A0. The model that describes the dynamic variation of temperature of water in the tank with time is given as : ....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution