Question Set

1. Thermal wells used in temperature measurements should have





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->.....is used for comparing the e.m.f.s, of cells, measurements of the thermal e.m.f.s, large potential differences and currents. It is also used for measuring low resistances.?....
QA->‘I have been touring different parts of the world. During these travels, I have had the good fortune to come into contact with several saints and maharshis. But I have frankly to admit that I have never come across one who is spiritually greater than Swami Sree Narayana Guru of Kerala” Whose words are these?....
QA->“During my travels throughout the world, I have had the good fortune to come in contact with several saints and maharishis... But I have frankly to admit that I have never come across one who is spiritually greater than Swami Narayana Guru or a person who is at par with him in spiritual attainment.” Who paid tribute in the above words after visiting Sree Narayana Guru?....
QA->The release of which fish into ponds and wells helps in controlling the mosquitoes?....
QA->The release of which fish into ponds and wells helps in controlling the mosquitoes ?....
MCQ->Two completely penetrating wells are located L (in metres) apart, in homogeneous confined aquifer. The drawdown measured at the mid point between the two wells (at a distance of 0.5 L from both the wells) is 2.0 m when only the first well is being pumped at the steady rate of Q1 m3/sec. When both the wells are being pumped at identical steady rate of Q2 m3/sec, the drawdown measured at the same location is 8, 0 m. It may be assumed that the drawdown at the wells always remains at 10.0 m when being pumped and the radius of influence is larger than 0.5 L Q1/Q2 is equal to....
MCQ->Consider the following assumptions of Bowditch method : 1. Angular measurements are more precise than linear measurements. 2. Linear measurements are more prescise than angular measurements. 3. Erros in linear measurements are proportional to L . 4. Correction to latitude or departure of any side = Total error in L (or D) x Length of that side / Perimeter of traverse. Which of these statements are correct ?....
MCQ->Thermal wells used in temperature measurements should have....
MCQ->Consider the following statements : 1. Infiltration galleries are placed along the river beds at a depth of 4 to 6 m. 2. The draw-down for the infiltration galleries is more than that for radial wells. 3. Clogging of pipe pores in inflitration galleries is less than that for radial wells. 4. The cost of extracting unit volume of water is more in case of infiltration galleries as compared to radial wells. Which of the statements given above is/are correct ?....
MCQ->If the solubilities of different components (in a liquid-liquid extraction system) increase with rise in temperature, then the temperature above which they dissolve completely is known as the critical solution temperature (CST or consolute temperature). If solubilities increase with decrease in temperature, then CST is the temperature below which they dissolve completely. If a binary system has no critical solution temperature, it implies that....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution