Question Set

1. If α is switch angle and R is radius of the turnout, the length of the tongue rail, is






Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The angle of elevation of the top of a hill at the foot of a tower is 60° and the angle of elevation of the top of the tower from the foot of the hill is 30°. If the tower is 50 m high, the height of the hill is—....
QA->The radius of a wire is decreased to its one third and if the volume remains the same how many times the length will increase?....
QA->A semiconductor device used to amplify or switch electronic signals and electrical . power?....
QA->A liquid will not wet the surface of solid if the angle of contact is which angle?....
QA->The complete reflection of a light ray reaching an interface with a less dense medium when the angle of incidence exceeds the critical angle is called Total Internal?....
MCQ->Consider the following locations of a turnout: 1. Tongue rail 2. Lead rail 3. Toe of switch 4. Crossing. Which is the correct sequence for a train to pass over the turnout from the facing direction?....
MCQ->If α is switch angle and R is radius of the turnout, the length of the tongue rail, is....
MCQ->You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy? Switch(config-if)# ip access-group 10 Switch(config-if)# switchport port-security maximum 1 Switch(config)# access-list 10 permit ip host 1 Switch(config-if)# switchport port-security violation shutdown Switch(config)# mac-address-table secure....
MCQ->If RADIUS = 3.0 the result of the following FORTRAN 77 program will be

REAL RADIUS, CAREA, SAREA, RATIO
PI
PI = 3.1416
READ , RADIUS CAREA = PI RADIUS RADIUS
SAREA = 2 RADIUS RADIUS
RATIO = CAREA/SAREA....
MCQ->Wearing locations of rails and their reasons are listed below : 1. Wear at end of rails : Loose fish bolts 2. Wear at sides of rail head : Constant lerake application 3. Wear on the top of rail head on tangent truck : Rigidity of wheel base 4. Wear on top of rail head on curves : Lesser area of contact between wheel and rail Which of the pairs given above are correctly matched ?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution