Question Set

1. The diameter of a bolt hole is taken as the nominal diameter of the bolt plus






Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A circular disc of copper has a symmetrical hole at its center. The disc is uniformly heated. The diameter of the hole will?....
QA->A metal plate with a circular hole at the centre is heated. What will happen to the area of the hole?....
QA->A metal sheet with circular hole is heated. what change will be in the hole?....
QA->A large tank having a small hole at the bottom is filled with water to a height h. if the stream of water coming out of the hole is directed vertically upwards it will?....
QA->A metal sheet with a circular hole is heated. The hole will?....
MCQ->The diameter of a bolt hole is taken as the nominal diameter of the bolt plus....
MCQ->The diameter of bolt hole for a bolt of nominal size 12 mm is:....
MCQ->If P1 is the initial tension due to tightening up the bolt and P2 is the external load on the bolt, then the resultant load (P) on a bolt may be obtained by using the relation (where a = Ratio of elasticity of connected parts to the elasticity of bolt)....
MCQ->When a bolt and nut is made of mild steel, then the effective height of nut is made equal to (where d = Nominal diameter of bolt)....
MCQ->The initial tension (in newtons) in a bolt used for making a fluid tight joint like steam engine cover joints, is calculated by the relation (where d = Nominal diameter of bolt in mm)....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution