Question Set

1. The development length of each bar of three bars bundled together is increased by





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->There are 50 students in a class. In a class test 22 students get 25 marks each, 18 students get 30 marks each. Each of the remaining gets 16 marks. The average mark of the whole class is :....
QA->A and B can do a work in 12 days B and C together can do it in 15 days and C and A together in 20 days. If A,B,C work together, they will complete the work in?....
QA->If a number is increased by 30% and then from the increased number its 30% is decreased. Then :....
QA->If the diameter of a circle is increased by 100%, its area is increased by :....
QA->If a bar magnet is cut length wise into 3 parts; what will the total number of poles be?....
MCQ->The development length of each bar of three bars bundled together is increased by....
MCQ->Four reinforcing bars of 30 mm diameter each, are bundled in contact. The lower two bars extend up to end supports. The distance between the points of termination of the upper bars, is kept....
MCQ->class Bar { } class Test { Bar doBar() { Bar b = new Bar(); / Line 6 / return b; / Line 7 / } public static void main (String args[]) { Test t = new Test(); / Line 11 / Bar newBar = t.doBar(); / Line 12 / System.out.println("newBar"); newBar = new Bar(); / Line 14 / System.out.println("finishing"); / Line 15 / } } At what point is the Bar object, created on line 6, eligible for garbage collection?....
MCQ->The length, coefficient of thermal expansion and Young's modulus of bar 'A' are twice that of bar 'B'. If the temperature of both bars is increased by the same amount while preventing any expansion, then the ratio of stress developed in bar A to that in bar B will be....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution