Question Set

1. A cut-through switch reads the entire packet before forwarding it to the destination segment



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A packet whose destination is outside the local TCP/IP network segment is sent to the ____ .....
QA->A semiconductor device used to amplify or switch electronic signals and electrical . power?....
QA->A person who always reads books....
QA->Reads....
QA->What do you call a segment of tapeworm?....
MCQ->A cut-through switch reads the entire packet before forwarding it to the destination segment....
MCQ->You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy? Switch(config-if)# ip access-group 10 Switch(config-if)# switchport port-security maximum 1 Switch(config)# access-list 10 permit ip host 1 Switch(config-if)# switchport port-security violation shutdown Switch(config)# mac-address-table secure....
MCQ->Which fields are contained within an IEEE Ethernet frame header? Source and destination MAC address Source and destination network address Source and destination MAC address and source and destination network address FCS field....
MCQ->The Corporate router receives an IP packet with a source IP address of 192.168.214.20 and a destination address of 192.168.22.3. Looking at the output from the Corporate router, what will the router do with this packet? Corp#sh ip route [output cut] R 192.168.215.0 [120/2] via 192.168.20.2, 00:00:23, Serial0/0 R 192.168.115.0 [120/1] via 192.168.20.2, 00:00:23, Serial0/0 R 192.168.30.0 [120/1] via 192.168.20.2, 00:00:23, Serial0/0 C 192.168.20.0 is directly connected, Serial0/0 C 192.168.214.0 is directly connected, FastEthernet0/0....
MCQ->Which of the following sentences are correct about a switch loop in a C program? 1: switch is useful when we wish to check the value of variable against a particular set of values. 2: switch is useful when we wish to check whether a value falls in different ranges. 3: Compiler implements a jump table for cases used in switch. 4: It is not necessary to use a break in every switch statement.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution