Question Set

1. Two inductors, L1 and L2, are in parallel. L1 has a value of 25 H and L2 a value of 50 H. The parallel combination is in series with L3, a 20 H coil. The entire combination is across an ac source of 60 Vrms at 300 kHz. The total rms current is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A charge of current in neighbouring coil will induce (contribute) a voltage (emf) in a coil is termed as?....
QA->A man who can swim 48 m/minute in still water. He swims 200 m against the current and 200 m with the current. If the difference between those two times is 10 minutes, what is the speed of the current?....
QA->A man who can swim 48 m/minute in still water. He swims 200 m against the current and 200 m with the current. If the difference between those two times is 10 minutes, what is the speed of the current?....
QA->Transformers, Microphones, Induction coil, Generators, Motors, Induction coil work on the principle of?....
QA->In an electron two person contested one of the candidates obtained 40 percent vote and he is declared elected at a margin of 300 vote. Then what is the is total number of voters?....
MCQ->Two inductors, L1 and L2, are in parallel. L1 has a value of 25 H and L2 a value of 50 H. The parallel combination is in series with L3, a 20 H coil. The entire combination is across an ac source of 60 Vrms at 300 kHz. The total rms current is....
MCQ->Six sets of electromagnetic waves are given below : 30 - 300 KHz 10 - 30 KHz 3 - 30 MHz 300 - 3000 KHz 30 - 300 MHz > 300 MHz There are designated in the following order....
MCQ->Two 10 H inductors are in parallel and the parallel combination is in series with a third 10 H inductor. What is the approximate total reactance when a voltage with a frequency of 7 kHz is applied across the circuit terminals?....
MCQ->In a series RC circuit, 12 V(rms) is measured across the resistor and 15 V(rms) is measured across the capacitor. The rms source voltage is....
MCQ->Two series resistors are connected to an ac source. If there are 7.5 V rms across one resistor and 4.2 V rms across the other, the peak source voltage is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution