Question Set

1. In an open-loop op-amp circuit, whenever the inverting input (–) is negative relative to the noninverting input (+), the output will:





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Which is electrical circuits used to get smooth de output from a rectified circuit called?....
QA->At the time of short-circuit; what will be the current in the circuit?....
QA->At the time of short-circuit, what will be the current in the circuit?....
QA->Whenever a body is immerced partially or completely in a fluid, it experiences an upward force. This is called,?....
QA->The output quality of printer is measured by..........
MCQ->In an open-loop op-amp circuit, whenever the inverting input (–) is negative relative to the noninverting input (+), the output will:....
MCQ->Which of the following sentences are correct about a for loop in a C program? 1: for loop works faster than a while loop. 2: All things that can be done using a for loop can also be done using a while loop. 3: for(;;); implements an infinite loop. 4: for loop can be used if we want statements in a loop get executed at least once.....
MCQ->It is suspected that the comparator in the figure given below has a problem. The inputs are activated in the table shown below and the corresponding outputs noted. What is most likely wrong with the circuit? For P0 – P3 = 1 and Q0 – Q3 = 0, P > Q = 1, P = Q = 1, P < Q = 0 For P0 – P3 = 0 and Q0 – Q3 = 1, P > Q = 0, P = Q = 1, P < Q = 1 For P0 – P3 = 1 and Q0 – Q3 = 1, P > Q = 0, P = Q = 1, P < Q = 0

....
MCQ->Consider the following statements, regarding an OP AMP: All types of negative feedback reduce non-linear distortion.All types of negative feedback reduce the output offset voltage.Non-inverting (current and voltage) feedback increases the input impedance.Inverting (current and voltage) feedback decreases input impedance. Which of the above statements is/are correct?....
MCQ->If an input signal is applied to the inverting input of an op-amp with the noninverting input grounded, the output signal would be opposite in polarity with the input.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution