Question Set

1. A Ge diode operated at a junction temperature of 27°C. For a forward current of 10 mA, VD is found to be 0.3 V. If VD = 0.4 V then forward current will be





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 01 Jun 2017 11.43 pm
    iD2 = (47.73) x 10 mA = 466 mA.
Show Similar Question And Answers
QA->Of the four locations mentioned below the highest inside temperature will be attained in the pressure cooker operated with the pressure valve open?....
QA->A man is facing East, then the turns left and goes 10 m, then turns right and goes 5 m, then goes 5 m to the South and from there 5 m to West. In which direction is he, from his original place ?....
QA->Speed of a swimmer when moving in the direction perpendicular to the direction of the current is 16 km/h, speed of the current is 3 km/h. So the speed of the swimmer against the current will be (in km/h):....
QA->A man who can swim 48 m/minute in still water. He swims 200 m against the current and 200 m with the current. If the difference between those two times is 10 minutes, what is the speed of the current?....
QA->Speed of a speed-boat when moving in the direction perpendicular to the direction of the current is 25 km/h, speed of the current is 5 km/h. So, the speed of the boat against the current will be:....
MCQ->A Ge diode operated at a junction temperature of 27°C. For a forward current of 10 mA, VD is found to be 0.3 V. If VD = 0.4 V then forward current will be....
MCQ->Which of the following conditions must be satisfied for a transistor to remain under saturation? Its collector to base junction should be under forward bias.Its collector to base junction should be under reverse bias.Its emitter to base junction should be under reverse bias.Its emitter to base junction should be under forward bias. Select the correct answer from the codes given below:....
MCQ->Which of the following characteristics of a silicon p-n junction diode make it suitable for use as ideal diode? It has low saturation current.It has high value of cut in voltage.It can withstand large reverse voltage.When compared with germanium diode, silicon diode shows a lower degree of temperature dependence under reverse conditions. Select the answer using the given below....
MCQ->The calibration data of a thermocouple with its cold junction at 0°C are given below. The hot junction of the thermocouple is placed in a bath at 80°C, while its cold junction is at 20°C. What is the emf of thermocouple ?....
MCQ->In given figure a silicon diode is carrying a constant current of 1 mA. When the temperature of the diode is 20°C, VD is found to be 700 mV. If the temperature rises to 40°C, VD becomes approximately equal to ....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution