Question Set

1. Find the flux crossing the plane surface defined by 0.5 ≤ r ≤ 3.5 m and 0 ≤ z ≤ 3 m. if





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 12.49 am
    .
Show Similar Question And Answers
QA->A​ ​light​ ​wave​ ​is​ ​incident​ ​over​ ​a​ ​plane​ ​surface​ ​with​ ​velocity​ ​X.After reflection​ ​the​ velocity​ ​becomes:....
QA->"Crossing the Threshold of Hope" "Gift and Mystery" “Roman Tryptych Meditations" "Rise up Let us Go"; "Memory and Identity" are the books written by?....
QA->The ratio of the monthly income of A and B is 7:5 and that of B and C is 19: The average monthly income of B and C is Rs. 17, find the montly Income of A?....
QA->ഇന്ത്യയുടെ ഭൂതല-ഭൂതല ( surface to surface) മിസൈൽ?....
QA->When yellow light is incident on a surface no electrons are emitted while green light can emit. If the red light is incident on the surface then?....
MCQ->Find the flux crossing the plane surface defined by 0.5 ≤ r ≤ 3.5 m and 0 ≤ z ≤ 3 m. if....
MCQ->If G is gauge distance and a is crossing, the distance between the nose of acute crossing and nose of obtuse crossing of a rail diamond, measured along the rail not forming the diamond, is....
MCQ->Statement: On an average, about twenty people are run over by trains and die every day while crossing the railway tracks through the level crossing. Courses of Action: The railway authorities should be instructed to close all the level crossings. Those who are found crossing the tracks, when the gates are closed, should be fined heavily

....
MCQ->The following statements relate to the pressure exerted by a fluid on a Submerged curved surface : 1. The vertical component of hydrostatic force acting on a submerged curved surface acts through the centre of volume of the fluid directly above the submerged area. 2. The horizontal component of the force acting on a curved surface is the hydrostatic force acting on the vertical projection of the curved surface. 3. The resultant force on a curved surface acts on the bottom of th6 curved surface. Of these statements :....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution