Warning: implode(): Invalid arguments passed in /www/wwwroot/jobquiz.info/mdiscuss.php on line 336
The power required by an impeller in a gas sparged system compare to the power required by impeller operating at same speed in a gas free liquid is usually ?->(Show Answer!)
Question Set

1. The power required by an impeller in a gas sparged system compare to the power required by impeller operating at same speed in a gas free liquid is usually





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Speed of a speed-boat when moving in the direction perpendicular to the direction of the current is 25 km/h, speed of the current is 5 km/h. So, the speed of the boat against the current will be:....
QA->Speed of a speed-boat when moving in the direction perpendicular to the direction of the current is 25 km/h, speed of the current is 5 km/h. So, the speed of the boat against the current will be:....
QA->The property of a liquid by which the free surface of liquid acts like a stretched membrane?....
QA->India govt plan to construct new corridor for high speed train with speed range 300-350 kmph. What is the present maximum speed of long distance train in India?....
QA->Raju Starts from A to B at a speed of 10 km/hr and returns with a speed of 15 km/hr. What is the average speed of the journey ?....
MCQ->The power required by an impeller in a gas sparged system compare to the power required by impeller operating at same speed in a gas free liquid is usually....
MCQ->The power required by an agitator operating in a gas-sparged system is....
MCQ->To keep the power input constant for a stirred vessel operating under fully developed turbulent flow conditions (constant power number), if the impeller diameter is increased by 20%, the impeller speed should be decreased by a factor of....
MCQ->Height of liquid in agitation tank is normally maintained equal to the tank diameter. However, if the tank is too tall and a large liquid hold up is desired, then two or more impellers mounted on the same shaft may be used. The clearance between the tank bottom and the bottom most impeller should be about (where, D = impeller diameter)....
MCQ->At low Reynold's number, the power (P) required for agitating a fluid in a stirred tank becomes independent of inertial forces. In this limit, indicate which of the following relations is satisfied: Po = ρ/ρN3 D5 : Power number Re = ρ N D2/μ: Reynold's number N is the impeller rotational speed, and D is the impeller diameter.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution