Question Set

1. To add 8 bit words, two IC 74181 can be cascaded.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->.In the question below three words are given.They are followed by four words one of which stands for the class to which these three words belong.Identify that word:Barbarous,Crude,Rude....
QA->.....is a device by virtue of which two persons at two different places can communicate. It consists of two main parts (i) a microphone and (ii) a receiver.?....
QA->A word given in Capital Letters is followed by four answer words. Out of these only one can be formed by using the letters of the given words. Find out that word— ENVIRONMENT....
QA->A word is given in capital letters. It is followed by four words. Out of these four words, three cannot be formed from the letters of the word in capital letters. Point out the word which can be formed from the letters of the given word in capital letters— ARCHITECTURE....
QA->P can do a work in the same time in which Q and R together can do it. If P and Q work together, the work can be completed in 10 days. R alone needs 50 days to complete the same work. then Q alone can do it in....
MCQ->Assertion (A): To add 8 bit words, two 1C 74181 can be cascaded.Reason (R): In 1C 74181 a sum greater than 15 leads to high carry out.

....
MCQ->To add 8 bit words, two IC 74181 can be cascaded.....
MCQ->Assertion (A): 1C 74181 is an ALU in TTL 7400 series.Reason (R): 1C 74181 can accept two 4 bit words and can perform any one of possible 16 arithmetic or logic operations.

....
MCQ->What will be the output of the program? TreeSet map = new TreeSet(); map.add("one"); map.add("two"); map.add("three"); map.add("four"); map.add("one"); Iterator it = map.iterator(); while (it.hasNext() ) { System.out.print( it.next() + " " ); }....
MCQ->Which of the following statements are correct about the Bitwise & operator used in C#.NET? The & operator can be used to Invert a bit. The & operator can be used to put ON a bit. The & operator can be used to put OFF a bit. The & operator can be used to check whether a bit is ON. The & operator can be used to check whether a bit is OFF.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution