Question Set

1. In microwave detector used in laboratory measurements of relative power levels, standing wave ratio is about





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The ratio of bases of a cylinder and a cone are in the ratio 3: Volume of cylinder and cone are in the ratio 9: then their heights are in the ratio?....
QA->What is the commonly used radio wave frequency in the microwave ovens to heat food?....
QA->.....is used for comparing the e.m.f.s, of cells, measurements of the thermal e.m.f.s, large potential differences and currents. It is also used for measuring low resistances.?....
QA->In a standing wave the distance between a node and adjacent antinode is______.?....
QA->A wave motion in which the particles of the medium vibrate parallel to the direction of propagation of wave is?....
MCQ->In microwave detector used in laboratory measurements of relative power levels, standing wave ratio is about....
MCQ->Consider the following assumptions of Bowditch method : 1. Angular measurements are more precise than linear measurements. 2. Linear measurements are more prescise than angular measurements. 3. Erros in linear measurements are proportional to L . 4. Correction to latitude or departure of any side = Total error in L (or D) x Length of that side / Perimeter of traverse. Which of these statements are correct ?....
MCQ->Match the following: Microwave Measuring Instruments Measurements EffectedA.Bolometer1.Reflection coefficientsB.VSWR meter2.Half power beam widthsC.Cavity wave meter3.Microwave powerD.Pattern recorder4.Microwave frequency

....
MCQ->Consider the following statements regarding phase sensitive detector The detector reads zero when phases of input signal and reference signal are different.The detector acts as a linear rectifier.The detector can be used as vector voltmeter. Of the above statements which are correct?....
MCQ->Assertion (A): In standing wave pattern, the nodes and anti nodes are separated by half wave-lengthReason (R): When line is terminated in resistance RL, the standing wave ratio is SWR = Z0/RL or RL/Z0

....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution