Question Set

1. The form grinding is used to grind gear teeth, threads, splined shafts and holes.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->In an automobile gear transmission the counter shaft drive gear is meshed with the gear on the:....
QA->Which teeth; is used for grinding?....
QA->An axe to grind....
QA->Tie rod ends have the following threads:....
QA->--------types of gear boxes are used in motor cycles....
MCQ->The form grinding is used to grind gear teeth, threads, splined shafts and holes.....
MCQ->A fixed gear having 200 teeth is in mesh with another gear having 50 teeth. The two gears are connected by an arm. The number of turns made by the smaller gear for one revolution of arm about the centre of bigger gear is....
MCQ->Hollow shafts can be made as strong as solid shafts by making the twisting moments of both the shafts same. Shafts made by __________ have residual stresses.....
MCQ->Gear A has a weight of 1.5 lb, a radius of 0.2 ft, and a radius of gyration of ko = 0.13ft. The coefficient of friction between the gear rack B and the horizontal surface is = 0.3. If the rack has a weight of 0.8 lb and is initially sliding to the left with a velocity of (vB)2 = 8 ft/s to the left. Neglect friction between the rack and the gear and assume that the gear exerts only a horizontal force on the rack.....
MCQ->If T is the actual number of teeth on a helical gear and φ is the helix angle for the teeth, then formative number of teeth is written as....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution