Question Set

1. In turbines, the fluid undergoes a continuous steady flow process and the speed of flow is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The process of transfer of heat from one point of a fluid to another part of a fluid by the movement of fluid itself is called?....
QA->Speed of a speed-boat when moving in the direction perpendicular to the direction of the current is 25 km/h, speed of the current is 5 km/h. So, the speed of the boat against the current will be:....
QA->Speed of a speed-boat when moving in the direction perpendicular to the direction of the current is 25 km/h, speed of the current is 5 km/h. So, the speed of the boat against the current will be:....
QA->A motorboat went the river for 14 km and then up the river for 9 km. If took a total of 5 hrs the entire journey. Find the speed of the river flow if the speed of the boat in still water is 5 km/h.....
QA->A motorboat went the river for 14 km and then up the river for 9 km. If took a total of 5 hrs the entire journey. Find the speed of the river flow if the speed of the boat in still water is 5 km/h.....
MCQ->In turbines, the fluid undergoes a continuous steady flow process and the speed of flow is....
MCQ->Bernoulli's equation for fluid flow is derived following certain assumptions. Out of the assumptions listed below, which set of assumptions is used in derivation of Bernoulli's equation ? A. Fluid flow is frictionless & irrotational. B. Fluid flow is steady. C. Fluid flow is uniform & turbulent. D. Fluid is compressible. E. Fluid is incompressible.....
MCQ->Match the following: List I List II A.Continuous and aperiodic1.Fourier representation is continuous and aperiodicB.Continuous and Periodic2.Fourier representation is discrete and aperiodicC.Discrete and aperiodic3.Fourier representation is continuous and periodicD.Discrete and periodic4.Fourier representation is discrete and periodic

....
MCQ->For turbulent flow (NRe > 2100) of low viscosity fluid (μ > 20cp) in steel pipes, the optimum inside pipe diameter is given by(where, Q = fluid flow rate, ft3/sec.ρ = fluid density, lb/ft3 μ = fluid viscosity, centipoise Di = optimum inside pipe diameter, inches)....
MCQ->A linear relationship is observed between speed and density on a certain section of a highway. The free flow speed is observed to be 80 km per hour and the jam density is estimated as 100 vehicles per km length. Based on the above relationship, the maximum flow expected on this section and the speed at the maximum flow will respectively be....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution