Question Set

1. If you wanted to deny FTP access from network 200.200.10.0 to network 200.199.11.0 but allow everything else, which of the following command strings is valid?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 01.57 am
    Extended IP access lists use numbers 100-199 and 2000-2699 and filter based on source and destination IP address, protocol number, and port number. The last option is correct because of the second line that specifies permit ip any any. (I used 0.0.0.0 255.255.255.255, which is the same as the any option.) The third option does not have this, so it would deny access but not allow everything else.
Show Similar Question And Answers
QA->Correct sentences among the following are: ) The tea is too hot that I cannot drink (2) Work hard, lest you should miss the chance (3) Unless you study well, you will fail (4) Unless you study well, you will pass....
QA->Belief that God is in everything and that everything is God....
QA->Who said ‘Happiness is when what you think; what you say; and what you do are in harmony’?....
QA->If you have a Power point show you created and want to send using E-mail to another teacher you can add the show to your E-mail message as an______....
QA->Which of the following is not a valid version of MS Office ?....
MCQ->If you wanted to deny FTP access from network 200.200.10.0 to network 200.199.11.0 but allow everything else, which of the following command strings is valid?....
MCQ->You configure the following access list: access-list 110 deny tcp 10.1.1.128 0.0.0.63 any eq smtp access-list 110 deny tcp any eq 23 int ethernet 0 ip access-group 110 out What will the result of this access list be?....
MCQ->You install the Routing and Remote Access service on a Windows 2000 Server computer in your network. Your network is not directly connected to the Internet and uses the private IP address range 192.168.0.0. When you use Routing and Remote Access to dial in to the server, your computer connects successfully, but you are unable to access any resources. When you try to piiig servers by using their IP addresses, you receive the following message: "Request timed out." When you run the ipconfig command, it shows that your dial-up connection has been given the IP address 169.254.75.182. What should you do to resolve the problem?....
MCQ->You are adding a new server to your network. The network uses TCP/IP. The new server will provide users with dial-up access to network resources. The data link communications protocol you choose for dial-up access must allow you to provide secure authentication. Which protocol should you choose?....
MCQ->The network uses TCP/IP as the only network protocol. You configure the remote access server on the network. Some users report that when they connect to the server they receive the following message |" IPX SPX compatible computer deported error 733" The EPP control network protocol for the network is not available. If the users allow the connection to continue they are able to connect to the services that use TCP/IP. You want to prevent this message from being displayed. What should you do?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution