Question Set

1. Which of the following modes are valid when a switch port is used as a VLAN trunk? Blocking Dynamic auto Dynamic desirable Nonegotiate Access Learning





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 01.57 am
    The valid modes of a VLAN trunk on a switch are dynamic auto, dynamic desirable, trunk (on), and nonegotiate.
Show Similar Question And Answers
QA->A person who is too concerned with small details or rules especially when learning or teaching Or one who makes a vain display of his learning, a conceited fellow....
QA->A semiconductor device used to amplify or switch electronic signals and electrical . power?....
QA->Which of the following is not a valid version of MS Office ?....
QA->Which of the following are valid minimum and maximum zoom size in MS Word ?....
QA->Which of the following is not a valid data type in Excel?....
MCQ->Which of the following modes are valid when a switch port is used as a VLAN trunk? Blocking Dynamic auto Dynamic desirable Nonegotiate Access Learning....
MCQ->You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy? Switch(config-if)# ip access-group 10 Switch(config-if)# switchport port-security maximum 1 Switch(config)# access-list 10 permit ip host 1 Switch(config-if)# switchport port-security violation shutdown Switch(config)# mac-address-table secure....
MCQ->Which of the following protocols are used to configure trunking on a switch? VLAN Trunk Protocol VLAN 802.1Q ISL....
MCQ->To configure the VLAN trunking protocol to communicate VLAN information between two switches, what two requirements must be met? Each end of the trunk link must be set to the IEEE 802.1e encapsulation. The VTP management domain name of both switches must be set the same. All ports on both the switches must be set as access ports. One of the two switches must be configured as a VTP server. A rollover cable is required to connect the two switches together. A router must be used to forward VTP traffic between VLANs.....
MCQ->What protocols are used to configure trunking on a switch? VLAN Trunking Protocol VLAN 802.1Q ISL....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution