Question Set

1. In offset sections, offsets or bends in the cutting plane are all:





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The process where the inner pages of a section is deliberately printed offset slightly towards spine fold ?....
QA->A person climbing a hill bends forward inorder to?....
QA->Plant bends towards the source of light on account of the movement of curvature known as?....
QA->Five equal forces of 10 N each are applied at one point and all are lying in one plane. If angles between them are equal, the resultant of these forces wil be?....
QA->Which allotrope of the carbon is used in cutting and drilling?....
MCQ->In offset sections, offsets or bends in the cutting plane are all:....
MCQ->In offset sections, the bends in the cutting plane are typically shown in the sectional view.....
MCQ->Offsets are measured with an accuracy of 1 in 40. If the point on the paper from both sources of error (due to angular and measurement errors) is not to exceed 0.05 cm on a scale of 1 cm = 20 m, the maximum length of offset should be limited to....
MCQ->In this type of view, the cutting plane line indicates both the location of the cutting plane and the direction of sight:....
MCQ->When a cutting plane coincides with a centerline, the cutting plane line takes precedence.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution